Tyan-computer S1854 Instrukcja Użytkownika Pobierz pdf (Strona 28)

http://www.tyan.com

Chapter 2

Board Installation

Some symptoms of incorrectly installed HDDs are:

 Hard disk drives are not auto-detected: may be a Master/Slave

problem or a bad IDE cable. Contact your vendor.

 Hard Disk Drive Fail message at bootup: may be a bad cable or

lack of power going to the drive.

 No video or beeps onbootup: usually means the cable is on back

wards.

 Hard drive lights are constantly on: bad IDE cable or defective drives/

motherboard. Try another HDD.

 Hard drives do not power up: check power cables and cabling.

May also be a bad power supply or IDE drive.

Connecting Floppy Drives

Pin 1 on the floppy cable is usually denoted by a red or colored stripe down

one side of the cable (see Figure 2-15 on the following page). Most of the

current floppy drives on the market require that the colored stripe be posi-

tioned so that it is right next to the power connector. In most cases, there will

be a key pin on the cable which will force you to connect the cable properly.

Figure 2-14

Pin 1

*Note: The image above is used to illustrate a concept and may not represent the actual

image of your motherboard.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Brak uwag

Tyan-computer S1854 Instrukcja Użytkownika Strona 28